On-demand: Requires manually connecting when access to the VPN is required.The gateway address is usually the same outside IP address. In most cases, this is the outside interface's IP address.
The portal address is the address where outside GlobalProtect clients connect. First successfully configure and test basic authentication, then add the Certificate Profile for certificate authentication. It is recommended to first test without a Certificate Profile, which allows for simpler troubleshooting, if the initial configuration does not work as intended. For iOS or Android devices to connect, GlobalProtect app can be used.Optional: NAT Policy for GlobalProtect clients to go out to the internet (if split tunneling is not enabled).Security and NAT policies permitting traffic between the GlobalProtect clients and Trust.Routing between the trust zones and GlobalProtect clients (and in some cases, between the GlobalProtect clients and the untrusted zones).
GlobalProtect client downloaded and activated on the Palo Alto Networks firewall.There is currently no specific troubleshooting information available for this configuration. The AP console sends this message: AccessPoint# *Aug 29 01:42:36.743: %DOT11-6-DISASSOC: Interfaceĭot11Radio0, Deauthenticating Station 384 Enter these commands in order to apply this MAC-based ACL to the radio interface:Īfter you configure this filter on the AP, the client with this MAC address, which was previously associated to the AP, is disassociated.Note: This ACL denies all traffic to and from the client with MAC address 384. Enter this command in order to enter the global configuration mode on the AP CLI:Īccess-list 701 deny 384 0000.0000.0000.Use the console port or Telnet in order to access the ACL through the Ethernet interface or the wireless interface.For instruction on how to configure a MAC address filter on the GUI, refer to the Configuring and Enabling MAC Address Filters section of the Cisco IOS Software Configuration Guide for Cisco Aironet Access Points, 12.3(2)JA.Ĭomplete these steps in order to filter MAC-based ACLs with the CLI. MAC address filters are powerful tools to control the forwarding of unicast and multicast packets. If your network is live, make sure that you understand the potential impact of any command. All of the devices used in this document started with a cleared (default) configuration. The information in this document was created from the devices in a specific lab environment. This document is not restricted to specific software and hardware versions.
0 kommentar(er)
